Photograph the tub and the route out. Access is what sets the price on this job, not the tub itself.
Get a Free QuoteHot tubs are the single most-underestimated removal there is. An acrylic shell looks light. The shell is not the problem - the problem is the closed-cell foam insulation packed around the plumbing, which absorbs water over years and turns a 300-pound tub into an 800-pound one that cannot be tipped, dragged or lifted by four people with enthusiasm.
The practical answer is that it comes out in pieces. We drain it, cut the shell down with a saw, and carry it out in sections. That is noisier and messier than the fantasy version where six people walk it out intact, and it is the version that actually works without taking your fence with it.
| Job | Typical price |
|---|---|
| Standard tub, ground level, clear access | $350 - $500 |
| Tub on a raised deck | $500 - $750 |
| Restricted access - narrow gate, side passage, stairs | $600 - $900 |
| Swim spa or oversized unit | quoted after a look |
| Add: surrounding deck sections removed | $150 - $400 |
Serving Great Falls, Black Eagle and Fort Benton.
Most of the hot tubs we remove died the same way: they were left full and unheated through a Montana winter. Water in the plumbing lines freezes and expands, the pipes split inside the cabinet where nobody can see, and the failure only becomes visible in spring when the thing is refilled and quietly empties itself into the yard.
At that point the arithmetic is usually bad. Re-plumbing a cabinet means pulling the foam and tracing every split line - frequently more than a used replacement tub costs. So the tub sits for a season or two, fills with rainwater and leaves, and then somebody decides the deck would be nicer without it.
The practical consequence for the quote: assume the tub is full of water and heavier than it looks. We drain everything before we start, including the several inches of stagnant water usually sitting under a collapsed cover, and we would rather know about that from a photograph than discover it on arrival.
Almost always, yes. Waterlogged foam makes these far heavier than they look and the gate or side passage is rarely wide enough. Cutting down is faster and safer than trying to walk it out whole.
The tub needs isolating at the breaker or disconnect box, and for a hard-wired unit that should be an electrician. We will not cut a line that might be live.
Doable but it changes the job. Send photographs of the tub and the route down, and we will quote it properly rather than guessing.
Photo of the tub plus the way out, and you'll have a number today.